Motor

Currently the motor is in mostly stock trim, with the enhancements being..

balance shaft elimination
ported 1g exhaust manifold w/ knife edged divider
ported 1g tb elbow
ported/polished exhaust side of head, cleaned intake side
new intake valves
ported stock 14b
ported 1g o2 housing
a/c elimination
mbc*
2.5" mandrel bent exhaust* w/ magnaflow converter** and dynaflow muffler**
electronic exhaust cutout before cat*
fmic**
2.5" charge pipes*
NGK plugs
NGK wires
new bearings
tps sensor
iac valve
new/rebuilt ecu (after i rebuild my current one, i will be looking for an eeprom ecu)

*need to be purchased/made

**needs to be installed

Task	Cost
port parts	$0
balance shaft elimination	$0
intake valves	$0
fmic	$150
mbc	$5
ngk plugs	$10
ngk wires	$40
crank	$102
tps	$0
caps for my ecu	$5
bearings	$80
total (not including eeprom & iac)	$392

When attempting a project like this it is very helpful to have friends who have a great deal of extra dsm parts laying around. So when something isn't working you can swap parts to narrow down the scope of the problem. It will greatly reduce the amount of parts you actually buy b/c you won't be replacing good parts with new ones when trying to solve your problem.